Kern County · Highway 223
Sealcoating in Arvin —
black, sealed, protected.
Arvin property owners have been calling the same Fresno number for sealcoating for a long time — (559) 442-4105, ours since the flip-phone era. On our scheduled Kern County runs, and the crew that shows up is the one that gave you the number.
Arvin works the ground where the valley floor meets the Tehachapi foothills — grapes, citrus and row crops right up against the mountain grade.
Expect field-edge approaches, labor-camp and packing-yard asphalt, and in-town driveways that cope with real summer heat bouncing off the foothill slopes.
Wind is Arvin’s wildcard: the gap winds that clear the air also drive grit across pavement, sandblasting sealcoat on exposed lots. We spec harder-wearing seal mixes and tighter re-coat cycles on the windward sides.
In Arvin that means foothill-edge field approaches, packing-yard asphalt, and in-town drives that bake against the Tehachapi grade all summer. We schedule Arvin work in efficient runs (Highway 223 carries the trip), so mobilization never pads your quote.
Sealcoat in Arvin
What sealcoating does here.
Watch any Valley parking lot go from black to gray and you’re watching the binder burn out of it. The sun does more damage here than the traffic does — oxidized asphalt turns brittle, cracks sooner, and unravels at the surface. Sealcoating is the scheduled defense: a wear layer that takes the UV so the asphalt underneath doesn’t have to, applied on a cycle that costs pennies against what repaving costs.
How the work goes down.
A real sealcoat job is mostly preparation. We clean the surface, prime the oil spots, treat the cracks with hot rubberized sealant, and only then put down two coats of commercial-grade sealer. Lots get done in phases around your business hours; stripes go back on after cure. Skip any of those steps and the seal peels early — so we don’t.
Why this shop
One shop, since 1990.
One shop, family-run, since 1990. No commissioned salesmen, no phone-center quotes for Arvin properties — the person who measures your job is the person who answers for it. CSLB C-32 #760658, verifiable in two clicks.
Call (559) 442-4105 for a free estimate in Arvin, or send the form and we’ll call you back within one business day.
Sealcoat questions
Asked before every
Arvin job.
How often should asphalt be sealcoated here?
In the Valley: 2–3 years for commercial lots, 3–5 for residential driveways. The sun here is harder on asphalt than the traffic is.
How long does sealcoating take to dry?
Foot traffic in a few hours, vehicles typically after 24 hours — faster in Fresno summer heat, longer in cool or humid weather. We schedule so the cure happens on your quiet hours, not your busy ones.
Is Arvin inside your normal service area?
Arvin work rides on our scheduled Kern County runs. Tell us your timeline when you call; we book those trips ahead, and grouping the jobs is exactly what keeps far-side pricing reasonable.